Wood Flooring in Eagleswood, NJ
Wood floor refinishing, installation and repair in Eagleswood, Ocean County.
- 1973 median year built
- 55.8% built before 1978
- 814 housing units
- Ocean County
The median home here dates to 1973 and about 55.8% of the housing predates 1978 — the two facts that shape most flooring work in this town.
What Eagleswood floors are usually made of
The median Eagleswood home dates to 1973, which puts most of the housing stock in the postwar era — typically 2¼-inch red oak strip over a wood subfloor, the most straightforward floor to refinish.
This is the case wood flooring work is built around. Red oak strip nailed over plywood or plank subfloor has adequate wear layer, takes stain evenly and responds predictably to sanding.
It is also the housing most likely to be on its first or second refinish, which usually means there is wood left to work with. In Eagleswood, 55.8% of homes predate 1978, so the age of the finish system is often the limiting factor rather than the age of the wood.
Services we provide in Eagleswood
Every service below is the same crew and the same method used across Ocean County — the page for each one says what it involves in Eagleswood specifically.
Refinishing & Sanding
Installation
Repair & Restoration
Stairs & Commercial
How Eagleswood compares
Housing here tracks the Ocean County median of 1976 closely.
At 55.8% pre-1978, Eagleswood sits in the newer half of the 185 towns we serve. Neighbouring Little Egg Harbor is a different picture — median 1987 against 1973 here — which is why we quote by address rather than by area. Eagleswood is about 46 miles from our base in Eatontown.
Housing data for Eagleswood
These are the Census figures behind everything above — published so you can check them rather than take our word for it.
| Median year built | 1973 |
|---|---|
| Built before 1978 (approx.) | 55.8% |
| Built before 1940 | 22.6% |
| Housing units | 814 |
| Population | 1,645 |
| County | Ocean County |
Source: US Census Bureau, ACS 2023 5-Year Estimates. See the full dataset.
Lead-safe requirements in Eagleswood
Roughly 55.8% of Eagleswood homes predate 1978, so whether the EPA lead-safe rule applies depends on the specific address rather than on the town.
In a town with mixed housing age this is a per-house question. Your municipal tax record lists the year built, and that is the number that decides it.
Where it applies, it applies to work disturbing painted surfaces — the trim and stair components at the edges of the floor, not the bare field.
Towns near Eagleswood
Frequently asked questions
Do you serve Eagleswood, NJ?
Yes. Eagleswood is one of the 185 New Jersey municipalities we cover, across nine counties.
How old are most homes in Eagleswood?
The median Eagleswood home was built in 1973, and about 55.8% of the housing stock predates 1978. Figures are from the US Census ACS 2023 5-year estimates.
Does the EPA lead-safe rule apply to my Eagleswood home?
About 55.8% of Eagleswood homes predate 1978, so it depends on the specific address. Check the year built on your municipal tax record.
Do I need a permit for wood flooring in Eagleswood?
Floor refinishing and like-for-like replacement generally do not require a permit in New Jersey. Structural work, subfloor replacement or changes to the building do. Confirm with the Eagleswood construction office for your specific scope.
How far in advance should I book?
It varies with season — heating season and the weeks before holidays are the busiest. Contact us with your timeframe and we will tell you honestly what is available.
What does wood flooring cost in Eagleswood?
We do not publish a per-square-foot figure, because the honest number depends on the floor: square footage is only the starting point, and edge work, stairs, closets, coat count, stain and lead-safe requirements all move it. We quote in writing after seeing the floor and taking moisture readings.
Get your Eagleswood floor quoted properly
We take moisture readings and check wear layer before putting a number on the job, so the quote reflects what your floor can actually support — not a rate per square foot applied blind.
Request a free estimate