Wood Flooring in Florence, NJ
Wood floor refinishing, installation and repair in Florence, Burlington County.
- 1972 median year built
- 58.9% built before 1978
- 5,007 housing units
- Burlington County
The median home here dates to 1972 and about 58.9% of the housing predates 1978 — the two facts that shape most flooring work in this town.
What Florence floors are usually made of
The median Florence home dates to 1972, which puts most of the housing stock in the postwar era — typically 2¼-inch red oak strip over a wood subfloor, the most straightforward floor to refinish.
This is the case wood flooring work is built around. Red oak strip nailed over plywood or plank subfloor has adequate wear layer, takes stain evenly and responds predictably to sanding.
It is also the housing most likely to be on its first or second refinish, which usually means there is wood left to work with. In Florence, 58.9% of homes predate 1978, so the age of the finish system is often the limiting factor rather than the age of the wood.
Services we provide in Florence
Every service below is the same crew and the same method used across Burlington County — the page for each one says what it involves in Florence specifically.
Refinishing & Sanding
Installation
Repair & Restoration
Stairs & Commercial
How Florence compares
Housing here runs about 22 years older than the Burlington County median of 1994.
At 58.9% pre-1978, Florence sits in the newer half of the 185 towns we serve. Neighbouring Mansfield is a different picture — median 1994 against 1972 here — which is why we quote by address rather than by area. Florence is about 41 miles from our base in Eatontown.
Housing data for Florence
These are the Census figures behind everything above — published so you can check them rather than take our word for it.
| Median year built | 1972 |
|---|---|
| Built before 1978 (approx.) | 58.9% |
| Built before 1940 | 28.2% |
| Housing units | 5,007 |
| Population | 12,798 |
| County | Burlington County |
Source: US Census Bureau, ACS 2023 5-Year Estimates. See the full dataset.
Lead-safe requirements in Florence
Roughly 58.9% of Florence homes predate 1978, so whether the EPA lead-safe rule applies depends on the specific address rather than on the town.
In a town with mixed housing age this is a per-house question. Your municipal tax record lists the year built, and that is the number that decides it.
Where it applies, it applies to work disturbing painted surfaces — the trim and stair components at the edges of the floor, not the bare field.
Towns near Florence
Frequently asked questions
Do you serve Florence, NJ?
Yes. Florence is one of the 185 New Jersey municipalities we cover, across nine counties.
How old are most homes in Florence?
The median Florence home was built in 1972, and about 58.9% of the housing stock predates 1978. Figures are from the US Census ACS 2023 5-year estimates.
Does the EPA lead-safe rule apply to my Florence home?
About 58.9% of Florence homes predate 1978, so it depends on the specific address. Check the year built on your municipal tax record.
Do I need a permit for wood flooring in Florence?
Floor refinishing and like-for-like replacement generally do not require a permit in New Jersey. Structural work, subfloor replacement or changes to the building do. Confirm with the Florence construction office for your specific scope.
How far in advance should I book?
It varies with season — heating season and the weeks before holidays are the busiest. Contact us with your timeframe and we will tell you honestly what is available.
What does wood flooring cost in Florence?
We do not publish a per-square-foot figure, because the honest number depends on the floor: square footage is only the starting point, and edge work, stairs, closets, coat count, stain and lead-safe requirements all move it. We quote in writing after seeing the floor and taking moisture readings.
Get your Florence floor quoted properly
We take moisture readings and check wear layer before putting a number on the job, so the quote reflects what your floor can actually support — not a rate per square foot applied blind.
Request a free estimate