Wood Flooring in Kenilworth, NJ
Wood floor refinishing, installation and repair in Kenilworth, Union County.
- 1955 median year built
- 86.9% built before 1978
- 3,058 housing units
- Union County
The median home here dates to 1955 and about 86.9% of the housing predates 1978 — the two facts that shape most flooring work in this town.
What Kenilworth floors are usually made of
With a median build year of 1955 and 9.8% of homes predating 1940, Kenilworth has a genuinely mixed housing stock — which means the floor has to be identified before the work is scoped.
A mixed-era town is the hardest one to generalise about. Two houses on the same street in Kenilworth can have completely different floors under the finish: original narrow board in one, postwar red oak strip in the other.
We do not assume. Wear layer, board width and species get checked on site, because the answer changes the method and the price.
Services we provide in Kenilworth
Every service below is the same crew and the same method used across Union County — the page for each one says what it involves in Kenilworth specifically.
Refinishing & Sanding
Installation
Repair & Restoration
Stairs & Commercial
How Kenilworth compares
Housing here tracks the Union County median of 1955 closely.
At 86.9% pre-1978, Kenilworth has the 7th oldest housing stock among the 185 towns we serve. Kenilworth is about 29 miles from our base in Eatontown.
Housing data for Kenilworth
These are the Census figures behind everything above — published so you can check them rather than take our word for it.
| Median year built | 1955 |
|---|---|
| Built before 1978 (approx.) | 86.9% |
| Built before 1940 | 9.8% |
| Housing units | 3,058 |
| Population | 8,339 |
| County | Union County |
Source: US Census Bureau, ACS 2023 5-Year Estimates. See the full dataset.
Lead-safe requirements in Kenilworth
About 86.9% of Kenilworth homes were built before 1978, so work that disturbs painted baseboards, shoe molding or stair components will usually fall under the EPA's lead-safe rule.
This is the normal condition of a Kenilworth job, not an exception to plan around. The exposure is at the edges of the floor — sanding equipment runs directly against painted trim.
Dust containment and lead-safe practice are different things. A containment system manages nuisance dust; the RRP rule addresses a regulated hazard and carries its own containment, cleaning and verification requirements. Ask about both, separately.
The pre-1978 figure is approximate — see the method note on our housing data page for how it is derived.
Towns near Kenilworth
Frequently asked questions
Do you serve Kenilworth, NJ?
Yes. Kenilworth is one of the 185 New Jersey municipalities we cover, across nine counties.
How old are most homes in Kenilworth?
The median Kenilworth home was built in 1955, and about 86.9% of the housing stock predates 1978. Figures are from the US Census ACS 2023 5-year estimates.
Does the EPA lead-safe rule apply to my Kenilworth home?
With roughly 86.9% of Kenilworth housing built before 1978, it applies to most addresses here. Your municipal tax record lists your year built, which is what decides it.
Do I need a permit for wood flooring in Kenilworth?
Floor refinishing and like-for-like replacement generally do not require a permit in New Jersey. Structural work, subfloor replacement or changes to the building do. Confirm with the Kenilworth construction office for your specific scope.
How far in advance should I book?
It varies with season — heating season and the weeks before holidays are the busiest. Contact us with your timeframe and we will tell you honestly what is available.
What does wood flooring cost in Kenilworth?
We do not publish a per-square-foot figure, because the honest number depends on the floor: square footage is only the starting point, and edge work, stairs, closets, coat count, stain and lead-safe requirements all move it. We quote in writing after seeing the floor and taking moisture readings.
Get your Kenilworth floor quoted properly
We take moisture readings and check wear layer before putting a number on the job, so the quote reflects what your floor can actually support — not a rate per square foot applied blind.
Request a free estimate