Wood Flooring in Union, NJ
Wood floor refinishing, installation and repair in Union, Union County.
- 1955 median year built
- 79.0% built before 1978
- 21,932 housing units
- Union County
The median home here dates to 1955 and about 79.0% of the housing predates 1978 — the two facts that shape most flooring work in this town.
What Union floors are usually made of
With a median build year of 1955 and 20.9% of homes predating 1940, Union has a genuinely mixed housing stock — which means the floor has to be identified before the work is scoped.
A mixed-era town is the hardest one to generalise about. Two houses on the same street in Union can have completely different floors under the finish: original narrow board in one, postwar red oak strip in the other.
We do not assume. Wear layer, board width and species get checked on site, because the answer changes the method and the price.
Services we provide in Union
Every service below is the same crew and the same method used across Union County — the page for each one says what it involves in Union specifically.
Refinishing & Sanding
Installation
Repair & Restoration
Stairs & Commercial
How Union compares
Housing here tracks the Union County median of 1955 closely.
At 79.0% pre-1978, Union sits in the oldest quarter of the 185 towns we serve. Neighbouring Maplewood is a different picture — median 1938 against 1955 here — which is why we quote by address rather than by area. Union is about 30 miles from our base in Eatontown.
Housing data for Union
These are the Census figures behind everything above — published so you can check them rather than take our word for it.
| Median year built | 1955 |
|---|---|
| Built before 1978 (approx.) | 79.0% |
| Built before 1940 | 20.9% |
| Housing units | 21,932 |
| Population | 60,119 |
| County | Union County |
Source: US Census Bureau, ACS 2023 5-Year Estimates. See the full dataset.
Lead-safe requirements in Union
About 79.0% of Union homes were built before 1978, so work that disturbs painted baseboards, shoe molding or stair components will usually fall under the EPA's lead-safe rule.
This is the normal condition of a Union job, not an exception to plan around. The exposure is at the edges of the floor — sanding equipment runs directly against painted trim.
Dust containment and lead-safe practice are different things. A containment system manages nuisance dust; the RRP rule addresses a regulated hazard and carries its own containment, cleaning and verification requirements. Ask about both, separately.
The pre-1978 figure is approximate — see the method note on our housing data page for how it is derived.
Towns near Union
Frequently asked questions
Do you serve Union, NJ?
Yes. Union is one of the 185 New Jersey municipalities we cover, across nine counties.
How old are most homes in Union?
The median Union home was built in 1955, and about 79.0% of the housing stock predates 1978. Figures are from the US Census ACS 2023 5-year estimates.
Does the EPA lead-safe rule apply to my Union home?
With roughly 79.0% of Union housing built before 1978, it applies to most addresses here. Your municipal tax record lists your year built, which is what decides it.
Do I need a permit for wood flooring in Union?
Floor refinishing and like-for-like replacement generally do not require a permit in New Jersey. Structural work, subfloor replacement or changes to the building do. Confirm with the Union construction office for your specific scope.
How far in advance should I book?
It varies with season — heating season and the weeks before holidays are the busiest. Contact us with your timeframe and we will tell you honestly what is available.
What does wood flooring cost in Union?
We do not publish a per-square-foot figure, because the honest number depends on the floor: square footage is only the starting point, and edge work, stairs, closets, coat count, stain and lead-safe requirements all move it. We quote in writing after seeing the floor and taking moisture readings.
Get your Union floor quoted properly
We take moisture readings and check wear layer before putting a number on the job, so the quote reflects what your floor can actually support — not a rate per square foot applied blind.
Request a free estimate